How to Remove a Pleated Blind?

How to Remove a Pleated Blind?
Pleated blind removal is a process that takes a few minutes and requires no tools when done in the right order. Removal need usually arises in three situations: washing the blind, removing it during a move, or taking the blind to a flat surface for repair/maintenance. The removal method varies by installation type. We explain each system separately below.
Before Removal: Preparation
- Close the blind completely (bring the fabric to the gathered position). Cords get tangled and the pleat pattern is disrupted when removing an open blind.
- If available, wrap the stretch film or packaging tape around the gathered part of the blind — pleats don't scatter during transport.
- Clear the work area. Prepare a clean and flat surface where you will place the removed blind.
Removal by Installation Type
| Installation Type | Removal Method | Caution |
|---|---|---|
| Screwed / clipped | Open the mounting clips at the four corners and remove the blind profiles from the fittings | Don't force the clips, they open with a "click" sound |
| Adhesive | Release the spring cord connection on the bottom profile, separate the blind from the profiles stuck to the glass | Adhesive profiles stay on the glass. If you want to remove them, heat with a hair dryer and peel off |
| Framed (Perfect Fit) | Pull back the runners of the frame that pass over the glass bead and remove the whole frame | The frame comes out as one piece, don't use tools |
| Guide-wired (sloped/ceiling) | Loosen the tension fittings of the side wires and separate the profiles from their runners | Note the ends so wire tension isn't lost |
Step by Step: Removal on Screwed System
- Close the blind completely and fix it in the gathered position.
- Open the covers of the mounting feet at the bottom corners. Remove the connection fittings at the cord ends by pushing outward.
- Separate the top profile from its slots by pulling it slightly forward from the top mounting feet.
- When all four connection points are freed, the blind separates completely.
- The mounting feet stay on the frame — no need to unscrew when reattaching.
Correct Storage After Removal
If the blind won't be used for a long time, store it in the closed position, wrapped in stretch film and flat (horizontally) in a dry environment. Don't close a wet or damp blind — mold and pleat deformation form on damp fabric left closed. A washed blind should be mounted after being dried in the closed position along the pleat line for at least 12 hours.
Reattachment
Installation is the reverse of removal: the top profile is seated on the feet, the cord connection fittings at the bottom corners are placed into the fitting slots with a "click" sound, and alignment is checked by opening and closing the blind a few times. If the blind opens crooked, one side's cord hasn't fully seated into its fitting — open the clips and reseat.
Avoid These Mistakes
- Trying to remove the blind while open — cords come out of the channel and get tangled.
- Forcing clips or fittings with a screwdriver — plastic parts crack.
- Removing the glass bead on the framed system — not needed, the frame separates with runners.
- Rolling up the blind after removal — pleats change direction, form is ruined.
Frequently Asked Questions


